SEGGER Development Kit Accessory for 38-pin Mictor Interface, 20-pin 0.1 in J-Link Interface 8.06.08 J-Link Mictor 38 Adapter

SEGGER 8.06.08 J-Link Mictor 38 Adapter is a specialized development kit accessory designed to connect a 38-pin Mictor interface with a 20-pin 0.1 inch J-Link interface.

This adapter implements the single target connector pinout specification as outlined in the ARM ETM Architecture Specification, ensuring compatibility and correct signal mapping between JTAG and ground pins.

The 38-pin Mictor end can be plugged directly onto the target device or connected via a trace cable, allowing flexible integration options depending on the development setup.

The opposite 20-pin flat cable side is designed to connect directly to SEGGER J-Link debug probes, facilitating seamless communication for debugging and programming embedded systems.

This Adapter is essential for precise, high-fidelity debugging tasks in industrial, laboratory, and manufacturing embedded software development environments where standardized interface compatibility is critical.

Compatible with both 38-pin Mictor and 20-pin J-Link interfaces. Adheres strictly to ARM's ETM pinout architecture for signal integrity. Provides flexible connection options with direct or trace cable connection. Enables efficient JTAG debugging and system analysis.

Robust build quality ideal for frequent development use. Supports advanced development, testing, and validation workflows. Explore EnvMart's broad selection of development tool accessories for comprehensive solutions in embedded system programming and debugging.